DESCO #19787 - Surface Resistance Meter Kit

Product Features:

• NEW Enclosure with Rubber Grip Edges
• Thinner and narrower design is easier to hold and provides protection from drops.
• NEW Quick Check Button
• Bypasses the 15 second electrification period to allow quick spot checks.
• NEW Battery Compartment
• Easy-to-access compartment without the need for tooling or probes.
• Digital Compliance Verification Surface Resistance Meter Kit*
• Measures resistance point-to-point(Rtt) or surface to ground (Rtg) of worksurfaces, flooring systems, garments, packaging, and other materials in accordance with ESD Association documents: ESD TR53, ANSI/ESD S4.1, ANSI/ESD S7.1, ANSI/ESD STM97.1 and other documents.
• Resistance Range: Greater Than 1.0 x 10³ ohms to Less Than 1.0 x 10¹² (+/-10% Accuracy)
• Determines if a surface is dissipative, conductive, or insulative for ESD control applications in electronics manufacturing or handling environments.
• Under Load Test Voltages (10V or 100V ±5%)
• Meets ANSI/ESD S20.20 resistance testing requirements for product qualification and compliance verification.
• Selectable Test Voltage
• Switches to appropriate test voltage (10V for tests <1 x 10⁶ or 100V for tests >1 x 10⁶) in AUTO mode or may be fixed to at 10V in HOLD mode.
• Ohm Values are Expressed with a Digital Mantissa and LED Exponent
• Provides an easy to read and accurate measurement.
• Pre-set 15 Second Electrification Period in Full Test Mode
• Meets the requirements of the ANSI/ESD S4.1 testing requirements.
• Temperature (Fahrenheit and Celsius) and Relative Humidity Measurements
• Measures temperature and relative humidity (during 15 second electrification period) as required by ANSI/ESD S20.20.
• NIST Calibrated with Certificate
• Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on calibration of Desco products, see Calibration.
• Made in the United States of America
• Made and stocked in Chino, CA.

• *19787 Digital Surface Resistance Meter Kit

• 1 Digital Surface Resistance Meter 

• 2 Shielded Test Leads, 5' Length 

• 2 Five Pound Electrodes 

• 2 AA Alkaline Batteries 

• 1 Gator Clip 

• 1 Plastic Carrying Case 

• 1 Certificate of Calibration

• For Digital Surface Resistance Meter only see 19788